HOW TO ATTACH A WATER TANK TO A LONGHAUL FRONT SLIDE

HOW TO ATTACH A WATER TANK TO A LONGHAUL FRONT SLIDE

1. Ensure that the power lead for the Longhaul kitchen light is plugged into the Anderson plug at the rear of the kitchen before you start.  (If the kitchen is already attached to the runners) 
2. Find the 6 @ M6 x 14 attachment bolts and nuts in the attachment kit and lubricate the bolts with WD 40 or similar.
3. Move the slide to the open position. Allow it to be locked in the open position.
4. Carefully lift the water tank & bracket assembly between the runners with the faucet on the left side of the kitchen. (best done with 2 people)
5. Align the rear hole on the bottom row of attachment holes on the bracket with the last hole (at the back) in the runner.
6. Place 1 of the M6 x 14 Bolts in the rear hole on each side. Add a flat washer and a nut and run the nut in but don’t fully tighten.
7. Then put the other 2 bolts in each side and tighten all three nuts and bolts using the Alen key provided.
8. Attach the wire to the water pump with the SAE plug and connect to fused power through the switch to 12 Volts DC.
9. Always turn the switch off when not using the system to take the load off the pump.